EHE LIGHT™ UV Hair Extension Removal Solution 30 ml

This is the dry-adhesive removal solution for the EHE LIGHT™ system, the product you need to remove UV extensions. It is formulated to penetrate the cured bond and weaken the polymer network, so that the bond goes from hard to soft and can be opened without forcing the hair.

Together with professional heat at 120°C and the removal tool, it completes the cycle of the system: you apply with light, you remove with the solution and heat, and the natural hair is clean and ready for a new application.

1. Apply 3 to 5 drops to each bond, making sure the solution reaches the top, the sides and the base.
2. Wait a few seconds for it to penetrate the adhesive.
3. Activate the bond with professional heat at 120°C.
4. Press the bond between your thumb and index finger: it should feel soft, slightly gel-like and easy to compress.
5. Slide the removal tool from the top edge of the bond, with a gentle, controlled movement.

Pro tip

Never force the removal. If the bond is still hard, add 2 or 3 drops and repeat the heat before checking again. The solution must penetrate before the heat, and heat is never replaced by force.

After removal, wash the hair thoroughly to remove every trace of solution. Once it is dry, you can reapply the extensions in the same appointment. The full protocol is in the application and removal guide.

• Close the bottle tightly after each use and store it at room temperature.
• Avoid contact with the eyes and scalp. If it happens, rinse thoroughly with water.
• For professional use only. Keep out of the reach of children.

The EHE LIGHT™ 20 g adhesive, in Transparent or Black, and the 395 nm UV activator device. If you are restocking both consumables, the adhesive and removal solution pack costs less.

Delivery rates are shown at checkout.

A question before you order? Message us on WhatsApp at +34 615 430 785 or at info@ehelight.es and the technical team will reply, usually within 24 hours.